@gpstar,
Thanks for all this info. I’m working on lashing up my 1984 wand to a spirit pack. I was planning on tossing an arduino in the spirit pack just to run cyclotron and powercell LEDs, but then have it communicate with the wand via serial. In the wand I was going to use another arduino wires up similarly to your keep alive setup. So on the factory board, is P008 just a high/low output based on the state of the rumble motor?
Thanks!
Thanks for all this info. I’m working on lashing up my 1984 wand to a spirit pack. I was planning on tossing an arduino in the spirit pack just to run cyclotron and powercell LEDs, but then have it communicate with the wand via serial. In the wand I was going to use another arduino wires up similarly to your keep alive setup. So on the factory board, is P008 just a high/low output based on the state of the rumble motor?
Thanks!
Statistics: Posted by Aaron Morris — April 25th, 2024, 9:24 am