This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.
Youll need this rotary encoder with thread https://www.ebay.co.uk/itm/325529510785 ... R4bH5o_DYw
EC11 one has thread , A,C,B solder points
On haslab board remove rotary encoder and de-solder from board.
white = B
Yellow =C
purple =A
Are the positions of wiring relative to encoder, it has them marked on the board. Solder extended cable matching those to positions on new encoder. Drill hole low down pack of motherboard , look for area to put it where you can close it (probably around the bottom somewhere. Fit it through hole , hold down with nut. Optionally buy a knob to put on it.
Youll need this rotary encoder with thread https://www.ebay.co.uk/itm/325529510785 ... R4bH5o_DYw
EC11 one has thread , A,C,B solder points
On haslab board remove rotary encoder and de-solder from board.
white = B
Yellow =C
purple =A
Are the positions of wiring relative to encoder, it has them marked on the board. Solder extended cable matching those to positions on new encoder. Drill hole low down pack of motherboard , look for area to put it where you can close it (probably around the bottom somewhere. Fit it through hole , hold down with nut. Optionally buy a knob to put on it.
Statistics: Posted by cybertron — March 7th, 2024, 6:18 am