To anyone that's working on this project, or gets to the Neutrik Connector on their pack, a piece oo advice from a stagehand.
If you purchase a Neutrik Speakon connector, it looks similar to the True1 connector, and you also purchase the wall connector as done in this very thread for True1, you can take that tip from the Speakon, pop it back through the barrel, and take the tip from the True1 and swap the Speakon tip for it, you now have a 4 connector Speakon tip in your True1 barrel, allowing you to use 4 wires from the pack.
I also have this available on Thingiverse to allow for a passthru into your wand, you would keep the True1 permanently connected in this instance, but pull the cannon connector and hose from the pack. I haven't made a female connector to go into the wand yet in case you got a male end by accident. ----- You actually insert the female True1 Connector into the Male connector which has the pins protected by a shroud. (That was very hard to explain without using the word foreskin)
https://www.thingiverse.com/thing:6748309
If you purchase a Neutrik Speakon connector, it looks similar to the True1 connector, and you also purchase the wall connector as done in this very thread for True1, you can take that tip from the Speakon, pop it back through the barrel, and take the tip from the True1 and swap the Speakon tip for it, you now have a 4 connector Speakon tip in your True1 barrel, allowing you to use 4 wires from the pack.
I also have this available on Thingiverse to allow for a passthru into your wand, you would keep the True1 permanently connected in this instance, but pull the cannon connector and hose from the pack. I haven't made a female connector to go into the wand yet in case you got a male end by accident. ----- You actually insert the female True1 Connector into the Male connector which has the pins protected by a shroud. (That was very hard to explain without using the word foreskin)
https://www.thingiverse.com/thing:6748309
Statistics: Posted by jle2199 — July 31st, 2025, 7:42 pm