Sorry for not updating this thread sooner but I’ve been busy with non-ghostbusters stuff.
I’ve been trying (and failing) over the last week or two to 3d print the FE variant goggles shell. Unfortunately putting all these new holes and gaps all over the place is causing significant bed adhesion issues. I’ve tried at least 4 times so far and I’ve only got one usable shell for my efforts. The rest were complete trash, straight in the bin. Unfortunately even use one usable shell has a slight layer shift on one side, not significant but bad enough that it would need sanding/filling and painting to hide the blemishes. I am attempting one more print overnight with some additional supports painted on in the hope it’ll keep still until the left and right sides join up. I will know in 11 hours. And if not, it’ll be a trip to Halfords for some olive green spray paint haha.
I’ve been trying (and failing) over the last week or two to 3d print the FE variant goggles shell. Unfortunately putting all these new holes and gaps all over the place is causing significant bed adhesion issues. I’ve tried at least 4 times so far and I’ve only got one usable shell for my efforts. The rest were complete trash, straight in the bin. Unfortunately even use one usable shell has a slight layer shift on one side, not significant but bad enough that it would need sanding/filling and painting to hide the blemishes. I am attempting one more print overnight with some additional supports painted on in the hope it’ll keep still until the left and right sides join up. I will know in 11 hours. And if not, it’ll be a trip to Halfords for some olive green spray paint haha.
Statistics: Posted by Mercifull — June 17th, 2025, 2:14 pm