Unlisted youtube link of video : https://youtu.be/c_HcUlsxkLs?si=AEJAhXBxeOl4R2Rt
Ok so i did get the propforge incandescent kit and i was able to combine it with the jupiter wand kit with realistic bargraph, i had to make a harness of wire connections for the jupiter kit because the bargraph normally is hard wired meaning the circuit board will be in the way of a pop mech.
So the board is viable but you need to create a set of leads to the bargraph so you can have a pop mech, so that was the one bit of hassle with this set up.
I combined those with the GB fans soundboard:
1) 12 volt battery goes to soundboard
2) continuous power lead from soundboard to wand (jupiter light kits power terminals)
3) Switched power terminals on soundboard to 6 volt buck converter, buck converter 6v output to prop forge kits power inputs
4)prop forge power switch terminals shorted so that it is always on
5) jupiter fire switch ground lead to fire terminal on soundboard
6) jupiter power on : connect two leads to the other terminals of switch then take those to the switch on terminals of gb fans soundboard
So when i switch on wand it draws 12 volt from soundboard, it is a dpst switch so one side is simply turning on the wand and its lights and drawing power from soundboard.
At the same time as i do that the other side is activating the soundboard telling it the system is turned on and to a) play power on sound and b) send power out to switched output, the switched output then sends 12 volts to buck converter which then sends 6 volts to light kit, light on pack come on alongside wand and power up sound and then when switching off, the power down sound plays and the soundboard instructs propforge kit to shutdown.
All on one battery.
Ok so i did get the propforge incandescent kit and i was able to combine it with the jupiter wand kit with realistic bargraph, i had to make a harness of wire connections for the jupiter kit because the bargraph normally is hard wired meaning the circuit board will be in the way of a pop mech.
So the board is viable but you need to create a set of leads to the bargraph so you can have a pop mech, so that was the one bit of hassle with this set up.
I combined those with the GB fans soundboard:
1) 12 volt battery goes to soundboard
2) continuous power lead from soundboard to wand (jupiter light kits power terminals)
3) Switched power terminals on soundboard to 6 volt buck converter, buck converter 6v output to prop forge kits power inputs
4)prop forge power switch terminals shorted so that it is always on
5) jupiter fire switch ground lead to fire terminal on soundboard
6) jupiter power on : connect two leads to the other terminals of switch then take those to the switch on terminals of gb fans soundboard
So when i switch on wand it draws 12 volt from soundboard, it is a dpst switch so one side is simply turning on the wand and its lights and drawing power from soundboard.
At the same time as i do that the other side is activating the soundboard telling it the system is turned on and to a) play power on sound and b) send power out to switched output, the switched output then sends 12 volts to buck converter which then sends 6 volts to light kit, light on pack come on alongside wand and power up sound and then when switching off, the power down sound plays and the soundboard instructs propforge kit to shutdown.
All on one battery.
Statistics: Posted by cybertron — October 15th, 2024, 12:07 am