Proton Packs • Re: Molding My First Pack

The fiberglass jacket came off (with some effort) and I had more bubbles than I wanted (and created some additional overhang risk) so decided to fill those with clay. Also - since I used plastic between the clay and fiberglass, there were a number of spots where it bunched or creased that created larger impressions that would just be annoying after a silicone pour so I filled some of that stuff with clay too in order to make removal simpler later.

Oh yeah and drilled fill and air vent holes (more lessons learned on that later)












Then it was time to clean off the buck and bolt everything up properly.

Statistics: Posted by Tvenk — September 4th, 2024, 3:18 pm

---