A lot of things got in the way of finishing this project. I need to jump back in the saddle and finish this up. I'll put a writeup of the pedal build and testing next week. I know I made a writeup and stored it in a document somewhere. It was frustrating enough that I can rewrite it, if needed.
I will say that the pedal really is not good for 3D printing. You can print it in TPU and get a couple stomps on it, but the layers will eventually break down. I think if you wanted a functional replica of the pedal, it would be best to print to make a mould and then cast the part.
I will say that the pedal really is not good for 3D printing. You can print it in TPU and get a couple stomps on it, but the layers will eventually break down. I think if you wanted a functional replica of the pedal, it would be best to print to make a mould and then cast the part.
Statistics: Posted by Shwalamazula — January 29th, 2024, 7:41 pm